Technology / Specs
TaylorMade M6 D-Type Driver
The TaylorMade M6 D-Type driver has the same technology as the M6 driver and adds a draw bias to the design. Learn more about these drivers here.
Injected for Speed™
To maximize the ball speed on every M6 D-Type driver, TaylorMade inspects each club and injects tuning resin into the bring the COR as close to the USGA limit as possible. Two screws on the face, one low-toe and one low-heel, are the entry point for the resin. COR is the measure of ball speed at different parts of the face. Maximizing the COR creates higher ball speed and distance.
Twist Face™ technology returns to the M6 driver, delivering straighter shots. The face of the driver is curved to reduce the effect of off-center hits. The high-toe area of the face is curved slightly open with more left. This corrects for a low, hooking shot. Conversely, the low-heel area is curved closed with less loft, correcting a high, slicing shot.
Aerodynamic Carbon Sole with “Inertia Generator”
The sole of the M6 driver has an aerodynamic shape, helping the club pass through the air easier and swing faster.
An Inertia Generator on the sole makes up the majority of the aerodynamic shape and stores 46 grams of weight low and back. Placing that amount of weight on the sole lowers the CG and increases launch angle and MOI.
The sole is also made with 54% more carbon fiber than the M4 driver. Using more carbon fiber let designers place more weight in the Inertia Generator.
An internal weight in the M6 D-Type driver is located towards the heel of the club. This gives the club a draw-bias. To also help with the draw-bias, designers made the design on the crown to look open at address, triggering the brain to close it more at impact.
The Hammerhead 2.0 slot is more flexible than the previous version, increasing the size of the sweet spot.
Check out the chart below to see the stock options for the TaylorMade M6 D-Type driver.
Item has been added to your cart.
PROCEED TO CHECKOUT
Because our price on this item is lower than the manufacturer's suggested retail price, the manufacturer does not allow us to show you our price until you place the item in your shopping cart. Adding this item won't require you to purchase the product. You can easily remove the product from your cart if you decide not to buy it.
Close & Remove From Cart